XPS Technical Support Forum

Jim,

What is the safe voltage range for the XPS-J1 module?

The reason I am asking is because I have the XPS-J1 installed in a Taranis transmitter body.  Most of the models in that Taranis use the XJT-D16 protocol, but two of them are configured to send SBUS out (for DragonLink) through the external module bay into which the XPS-J1 is currently installed.  The Taranis indicates that the voltage for its SBUS output is at the battery voltage, around eight volts.

If I were to accidentally change to a model that uses SBUS while the XPS-J1 is still installed, would the SBUS signal and voltage levels damage the XPS-J1? 

Thank you,

Paul

ALL of our transmitter modules are designed for operation up to 16V. 8 cell Nimh batteries, commonly used in the older transmitters were often times more than 12V right off of the battery charger. We had to make sure that the module would handle this.

Ok good. Thanks.