XPS Technical Support Forum

The new version of the X10+ is in final testing.  This version offers substantially more features than the original, including full setup all of those features wirelessly via any smart device or PC web browser - no more cables or specific software needed!  Wireless firmware updates too!

The size is 0.150" taller, but the same width as the existing unit.  There are now two LEDs to show the status of both receivers independently.

The X10+ supports up to 40V now, so you can use it with 24V robotic setups safely.

Jim,

I'm in!

Paul

Any news on a release date?

No, not yet.

(10-24-2024, 12:03 PM)XPS Wrote: [ -> ]No, not yet.

So, 6 months since, any movement on V3?
       -vvp

No, we have no news. We are still testing while learning the new electronics assembly system. We are now making 100% of everything (board assembly) in-house instead of using a 3rd party.

Jim,

Will the X10+v3 take a PPM input?

Thanks,

Paul

No, that was not part of the design requirement, but it easily could.

Ok, thanks for the information.

(04-23-2025, 12:13 AM)XPS Wrote: [ -> ]No, we have no news.  We are still testing while learning the new electronics assembly system.  We are now making 100% of everything (board assembly) in-house instead of using a 3rd party.

Was making out my Xmas list ...