+- XPS Technical Support Forum (https://www.xtremepowersystems.net/forum)
+-- Forum: XPS Products (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=1)
+--- Forum: XtremeLink Radio System (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=2)
+---- Forum: Receivers (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=7)
+----- Forum: Nano (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=19)
+----- Thread: 2 nanos (/showthread.php?tid=163)
2 nanos - rlocke - 07-12-2025
i tried to get 2 nanos to bind as master and slave to no avail. i tried multiple times. each of the nanos worked on channel 1 only.
i gave up and tried to bind both as single use RXs but they only worked on ch 1.
what am i to do?
ron
RE: 2 nanos - XPS - 07-14-2025
Do a RESET of the Nanos. That will reset the channel mapping and enable all of the outputs. Are you preforming the master/slave binding correctly? Most people don't realize that BOTH receivers are bound together at the exact same time.
See here:
https://www.xtremepowersystems.net/forum/showthread.php?tid=2