+- XPS Technical Support Forum (https://www.xtremepowersystems.net/forum)
+-- Forum: XPS Products (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=1)
+--- Forum: XtremeLink Radio System (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=2)
+---- Forum: Transmitter Modules (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=5)
+----- Forum: Multiplex EVO and Profi (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=16)
+----- Thread: XPS module in EVO (/showthread.php?tid=193)
XPS module in EVO - erhard52 - 03-11-2026
this is my trouble.
per XPS manual it says the transmitter module should turn green after successful binding, which it does in my case BUT when after binding i power off and on the system for regular use the transmitter module LED flickers fast in green. i do not find any info in the manual and AI in its infinite wisdom says it is in range test mode
i do not know if that should again be solid green so why the flicker?
RE: XPS module in EVO - XPS - 03-19-2026
That is correct. That means the transmitter is in a hopping mode. Every single on/off is a different frequency being used. V3.x modules offered frequency hopping. So you have a v3.x module and are in one of the frequency hopping modes. This is perfectly normal... and the antenna is left ON during a range test.