+- XPS Technical Support Forum (https://www.xtremepowersystems.net/forum)
+-- Forum: XPS Products (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=1)
+--- Forum: XtremeLink Radio System (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=2)
+---- Forum: Receivers (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=7)
+----- Forum: RFU (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=20)
+----- Thread: Using two RFUs for redundancy (/showthread.php?tid=196)
Using two RFUs for redundancy - flyingw - 07-07-2026
Jim,
I want to set up a system using an X10+v2 and two RFUs. I understand that first I must configure the X10+v2 AUX port as a redundant receiver port.
How to I bind both RFUs to work together with the X10? There is no mention of that configuration in the RFU manual. The Nano Rx has instructions for setting up a "master/slave" (you may want to update that language) arrangement - would that procedure be the same for RFUs?
Thanks,
Paul
RE: Using two RFUs for redundancy - XPS - 07-13-2026
All receivers can be setup as master and slave the same way.
RE: Using two RFUs for redundancy - flyingw - 07-14-2026
Ok thanks Jim, Paul