+- XPS Technical Support Forum (https://www.xtremepowersystems.net/forum)
+-- Forum: XPS Products (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=1)
+--- Forum: XtremeLink Radio System (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=2)
+---- Forum: Receivers (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=7)
+----- Forum: RFU (https://www.xtremepowersystems.net/forum/forumdisplay.php?fid=20)
+----- Thread: RFU coax minimum bend radius (/showthread.php?tid=31)
RFU coax minimum bend radius - flyingw - 06-05-2021
Jim,
On the RFU's coax antenna leads, what is the minimum bend radius that will not cause any reduction in signal strength?
I understand that the bare tip must be kept straight, and that the angled antennas must be at least two inches apart.
Thanks,
Paul
RE: RFU coax minimum bend radius - XPS - 06-05-2021
The only part you need to worry about keeping straight in the white tipped portion. You can use any type of bend radius on the black part of the coax.