08-30-2024, 08:51 AM
Ron,
If you must locate them close together, then servo pin end to servo pin end would be better than stacked. If stacked, then the antennas would be too close to each other. The XPS recommendation was to locate the antenna at least two inches away from other electronics or wiring (same rule applies to any RC receiver setup).
Paul
If you must locate them close together, then servo pin end to servo pin end would be better than stacked. If stacked, then the antennas would be too close to each other. The XPS recommendation was to locate the antenna at least two inches away from other electronics or wiring (same rule applies to any RC receiver setup).
Paul