Try to run Nano's with Edge Taranis

[adnapak]

Too old to fly, need toys.

Trying to set up 4 separate engine running tests using a Taranis 9D plus.
Require Thr. Control on all.
Upgraded to edgetx-x9d+, 2.9.2 XJT_ACCST_2.1.0_FCC.frk

This XJT output binds fine with RM R88 Rx’s and similar.
There is no output option apart from XJT in the Tx.

Extreme nano’s accept and run  XJT from the Xtreme XPS-J1 module but not from the internal Taranis XJT module.
Not into these things, but I thought that XJT is XJT regardless.

Would prefer not to use the J1 module, so is there a way around this?

Is it to do with protocols, in which case just have to live with it. 

Any thoughts?

Regards,