I have a model set up with a receiver talking SBUS to an X10+v1. To set the failsafe servo positions I first power up the transmitter and airplane and operate the controls and make sure that the servos are working correctly. Then I press the programming button on the X10 and wait until it goes off, then blinking alternating red and green. Then release.
Only thing, when I press the programming button the led never goes off, it just blinks on and off green. Same behavior with the X10+v2.
It works as described in the manual when the receiver and X10 are configured for Extreme protocol, but not SBUS.
Am I missing something?
Thanks,
Paul
Only thing, when I press the programming button the led never goes off, it just blinks on and off green. Same behavior with the X10+v2.
It works as described in the manual when the receiver and X10 are configured for Extreme protocol, but not SBUS.
Am I missing something?
Thanks,
Paul