03-14-2026, 11:06 AM
I looked in the Spektrum manual for the SPM4651T receiver and saw that the connector has +5v, GND, Signal and no connection. It's just three connections. Make an adapter that puts the wires into a servo plug to connect to the X10.
The X10 manual says that it can be configured to take Spektrum Satellite protocol as an input signal. I would do that first.
I have never used Spektrum equipment before, but I imagine that you first have to tell the TX16's 4n1 module to talk Spektrum protocol. Then connect the receiver to the X10 and put the receiver into bind mode by powering up the X10. The X10's instructions cover that part, but I do not know the specifics on how to bind a Spektrum receiver and transmitter.
The X10 manual says that it can be configured to take Spektrum Satellite protocol as an input signal. I would do that first.
I have never used Spektrum equipment before, but I imagine that you first have to tell the TX16's 4n1 module to talk Spektrum protocol. Then connect the receiver to the X10 and put the receiver into bind mode by powering up the X10. The X10's instructions cover that part, but I do not know the specifics on how to bind a Spektrum receiver and transmitter.