thanks - i did miss this last page - will try it
i think i am getting to the end of the rope and it is not working
i connect the spektrum satellite receiver to the x10 v2. the spektrum is already bound to the tx16s in DSMX 22ms mode.
i go to LED white - spektrum bind mode
select binding ode 3 flashed = DSMX 22ms.
the i power off the x10 and connected receiver - then power on and receiver binds again to the tx16s but x10 keeps blinking and no servo moves
so x10 and receiver do not connect
--
what i do not understand is this. i am setting all up for spektrum on the x10 and we know it doe not work in the end.
then when i reconnect my RFU to x10 v2 and turn on the multiplex with XPS module it immediately reconnects. it is as if the x10 was never programmed in the spektrum mode. how is this possible?
i think i am getting to the end of the rope and it is not working
i connect the spektrum satellite receiver to the x10 v2. the spektrum is already bound to the tx16s in DSMX 22ms mode.
i go to LED white - spektrum bind mode
select binding ode 3 flashed = DSMX 22ms.
the i power off the x10 and connected receiver - then power on and receiver binds again to the tx16s but x10 keeps blinking and no servo moves
so x10 and receiver do not connect
--
what i do not understand is this. i am setting all up for spektrum on the x10 and we know it doe not work in the end.
then when i reconnect my RFU to x10 v2 and turn on the multiplex with XPS module it immediately reconnects. it is as if the x10 was never programmed in the spektrum mode. how is this possible?