03-21-2026, 04:20 PM
another scary observation.
while setting up another plane with x10v1 and RFU everything seemed ok and i turned off the transmitter and voila one aileron servo went to the full deflection. turning the transmitter on brought it back , turned off again and all servos stayed where they were.
my failsafe is 'keep last position'
a few minutes later the same happened but a different servo.
now in a possible defense of the system i need to mention this: the receiver and servo voltage was very low - clearly below 5V and most likely around 3.8-4V
i know that is not good and i also realized later that the RFU LED was RED which i think indicates a low voltage situation
while setting up another plane with x10v1 and RFU everything seemed ok and i turned off the transmitter and voila one aileron servo went to the full deflection. turning the transmitter on brought it back , turned off again and all servos stayed where they were.
my failsafe is 'keep last position'
a few minutes later the same happened but a different servo.
now in a possible defense of the system i need to mention this: the receiver and servo voltage was very low - clearly below 5V and most likely around 3.8-4V
i know that is not good and i also realized later that the RFU LED was RED which i think indicates a low voltage situation