03-25-2026, 12:35 PM
The SRXL protocol used by the newer Spektrum receivers is not supported by the X10+.
As far as the scope output, you are likely picking up the RF transmissions on the servo itself. All channels are output by the same CPU, so they should all look perfectly crisp. Turn off the EVO radio after a connection has occurred to see if there is a difference. You are using clip leads instead of scope probes, so those will pick up everything signal wise, and the servo itself could be the reason. If in doubt, plug the servo and check the output from the X10+ directly.
As far as the scope output, you are likely picking up the RF transmissions on the servo itself. All channels are output by the same CPU, so they should all look perfectly crisp. Turn off the EVO radio after a connection has occurred to see if there is a difference. You are using clip leads instead of scope probes, so those will pick up everything signal wise, and the servo itself could be the reason. If in doubt, plug the servo and check the output from the X10+ directly.