Mismatch after AutoMatch

[Robert]

Those instructions (in blue on page 36 of the manual) are only for when using servos that have a failsafe when the signal stops.    Only follow instructions on that page if you have servos that have a failsafe that can not be disabled.  Otherwise, follow the instructions starting on page 37.  You stated you are using Futaba servos, so do NOT follow those instructions on page 36 as those do not apply to you.

You should retry the AutoMatch (following the instructions starting on page 37), leaving the servos plugged in.  Make sure you make no adjustments to the EPA in the X24 or your transmitter afterwards.

You could try u plugging the slave servo and looking at the max current and then doing the same with just the slave servo.  Maybe there is a mechanical binding issue at some point during the throw.

Copy that Jim. I will do as you suggest. I will report back shortly.....