04-28-2021, 02:35 AM
Well, you definitely found the problem. It sounds like you have the center of this servo really far off from dead center (1500us). If you drive a servo beyond it's pulse limits (less than 800us or greater than 2200us) the servo will just free wheel, and the AutoMatch would go through. However, during normal use at the end they could definitely fight.
Are you using the servo reverse option for the slave channel? What is the CENTER value for the master and slave servos? They both should be very close to 1500us. What servo group number are you using? What are the endpoint values you are you using for the master?
Again, do NOT follow the instructions on page 36 - they do not apply to you. Follow the instructions on page 37 and later.
You are the only person ever have a problem with the AutoMatch feature (that wasn't a mechanical binding issue at the very end of the AutoMatch). We have not had anyone report what you are seeing, so we are a bit stumped. Other than a pulse limit, the only thing that might cause this would be a defective X24. The AutoMatch table is stored in the flash memory. If you changed which group was used for that match (like trying it on the other aileron group that works) and you see the same issue then it would rule out a faulty X24.
Are you using the servo reverse option for the slave channel? What is the CENTER value for the master and slave servos? They both should be very close to 1500us. What servo group number are you using? What are the endpoint values you are you using for the master?
Again, do NOT follow the instructions on page 36 - they do not apply to you. Follow the instructions on page 37 and later.
You are the only person ever have a problem with the AutoMatch feature (that wasn't a mechanical binding issue at the very end of the AutoMatch). We have not had anyone report what you are seeing, so we are a bit stumped. Other than a pulse limit, the only thing that might cause this would be a defective X24. The AutoMatch table is stored in the flash memory. If you changed which group was used for that match (like trying it on the other aileron group that works) and you see the same issue then it would rule out a faulty X24.