Mismatch after AutoMatch

[XPS]

1) You can NEVER increase the throw (increase the end point) after doing an AutoMatch. You can decrease it, but not increase it. If you do, you have to re-do the AutoMatch. You always want the absolute maximum throws possible (without mechanical binding), and then set the end points where you want them permanently. Also, never change the end points in the transmitter (at all), or you have to re-do the AutoMatch. You always want to use the X24 for everything though because it uses a 65536 step resolution, compared maximum of a 4096 step resolution for high-end radio systems.

2) Centering/sub-trim is not an issue. The issue only pertains to end points.