10-24-2021, 12:58 PM
(10-24-2021, 04:39 AM)XPS Wrote: You can do that but we recommend powering the RFU using only one of the X10+ boards - so in your Y-cable, pull the power wire from one of that plugs going into either X10+.
Thanks for getting back to me. I must be doing something wrong as I have no power to the second X10 after cutting the power (middle red) lead on the Y harness to the second X10 board. Nothing was done to the male to male wires.
RFU has 3 wires on it. The one X10 with the battery connected to it has 3 wires on it and the other X10 has 2 wires on it (just brown and orange) as with the middle red is cut on the Y harness.
thanks for your time and support