06-01-2021, 04:57 PM
Jim,
X16 setup. TX16S. Have set up all ch OK.
Not getting the sequencers I want.
Retracts and doors, Ch 5 on 3 pos switch.
X16 Ports A2 and B2 output from Ch 5.
Servos work OK.
Now to the sequencer: Trigger at 1500.
Tx Ch 5 Sw up Seq#1 triggers doors down. Port A2
Tx Ch 5 Sw up Seq#2 triggers gear down. Port B2
Not set up yet.
Tx Ch 5 Sw dn Seq#3 triggers gear up. Port B2
Tx Ch 5 Sw dn Seq#4 triggers doors up. Port A2
When all sequencers disabled, servos work. Expected.
One enabled, wrong servo works.
Both enabled, nothing works.
So tried duplicating Ch5 as Ch13 in Tx.
Ch 5 Seq#1 doors down. Port A2
Ch 13 Seq#2 gear down. Port B2
Same thing. Tx outputs do show in X16.
From reading the X16 manual am I misunderstanding the process?
Quite possible.
Can set it up from the Tx, but reckon that the X16 should do it too.
Cheers,
X16 setup. TX16S. Have set up all ch OK.
Not getting the sequencers I want.
Retracts and doors, Ch 5 on 3 pos switch.
X16 Ports A2 and B2 output from Ch 5.
Servos work OK.
Now to the sequencer: Trigger at 1500.
Tx Ch 5 Sw up Seq#1 triggers doors down. Port A2
Tx Ch 5 Sw up Seq#2 triggers gear down. Port B2
Not set up yet.
Tx Ch 5 Sw dn Seq#3 triggers gear up. Port B2
Tx Ch 5 Sw dn Seq#4 triggers doors up. Port A2
When all sequencers disabled, servos work. Expected.
One enabled, wrong servo works.
Both enabled, nothing works.
So tried duplicating Ch5 as Ch13 in Tx.
Ch 5 Seq#1 doors down. Port A2
Ch 13 Seq#2 gear down. Port B2
Same thing. Tx outputs do show in X16.
From reading the X16 manual am I misunderstanding the process?
Quite possible.
Can set it up from the Tx, but reckon that the X16 should do it too.
Cheers,