06-05-2021, 07:01 PM
(06-05-2021, 01:59 AM)XPS Wrote: We have not had any other customers (and these are used primarily with the jet crowd, because of the sequencer) state they had any issues. We will grab one and try setting it up per our manual to see if we have missed something.
This is where I'm at.
I'm assuming that this is just a case sort of loop and no condition is being met.
20 years since I have done any coding.
Tested the outputs from the sequencer. Full V. is there.
Output ports A2, B2 OFF
Sequence #1 Door down Trigger 1500
Pos 1 1100 Delay 5
Pos 2 1100
Pos 3 1100
Sequence #2 Gear down Trigger 1500
Pos 1 1100 (Tried changing to 1000)
Pos 2 1100
Pos 3 1100
Sequence #3 Gear Up Trigger 1500
Pos 1 1800 Delay 10
Pos 2 1800
Pos 3 1800
Sequence #4 Door up Trigger 1500
Pos 1 1800 (Tried changing to 1900)
Pos 2 1800
Pos 3 1800
Regards,