06-12-2021, 08:57 PM
Both the X16's are version 1.0 Firmware.
Have set both units up as follows to test, hopefully done it by the manual.
Doors: Seq1: Ch5 Trigger 1500 Port A2 Speed 2% Pos1:1000 (Hold Off) Delay 0 Pos2:1800 Delay 6 Pos3:1800 Delay 0
Gear: Seq2: Ch5 Trigger 1500 Port B2 Speed 1% Pos1:1000 (Hold Off) Delay 4 Pos2:1800 Delay 0 Pos3:1800 Delay 0
One unit works, the other ignores 4 sec time delay on Seq 2 Pos1: Gear down, but works on Gear up.
That's what I want to do, should this be Ok within your parameters?
Apart from this the units are great.
Have set both units up as follows to test, hopefully done it by the manual.
Doors: Seq1: Ch5 Trigger 1500 Port A2 Speed 2% Pos1:1000 (Hold Off) Delay 0 Pos2:1800 Delay 6 Pos3:1800 Delay 0
Gear: Seq2: Ch5 Trigger 1500 Port B2 Speed 1% Pos1:1000 (Hold Off) Delay 4 Pos2:1800 Delay 0 Pos3:1800 Delay 0
One unit works, the other ignores 4 sec time delay on Seq 2 Pos1: Gear down, but works on Gear up.
That's what I want to do, should this be Ok within your parameters?
Apart from this the units are great.