06-13-2021, 08:31 AM
So, now one works? Both units should do the same thing. Make sure that you don't have some other sequencer interfering with the sequence you are trying to use. If in doubt, do a RESET to defaults from the SYSTEM menu.
Your settings are fine, and are very common for a gear door setup. We are guessing that since one unit works and the other doesn't that you probably have some other sequencer interfering or you don't have A2 or B2 disabled in the OUTPUT PORTS setup.
We were reviewing the documentation for the sequencers in the manual and noticed a mistake about the order of sequencing for the backwards direction. Delay 1 was shown twice instead of it being Delay 2 and then Delay 1. The documentation has been updated and can be downloaded from the MANUALS section of our website.
Your settings are fine, and are very common for a gear door setup. We are guessing that since one unit works and the other doesn't that you probably have some other sequencer interfering or you don't have A2 or B2 disabled in the OUTPUT PORTS setup.
We were reviewing the documentation for the sequencers in the manual and noticed a mistake about the order of sequencing for the backwards direction. Delay 1 was shown twice instead of it being Delay 2 and then Delay 1. The documentation has been updated and can be downloaded from the MANUALS section of our website.