06-13-2021, 08:10 AM
All receivers will bind to all transmitter modules. However, not all receivers will "connect" with all transmitter modules. The reason? Any v1.x/2.x receiver is not compatible with any v3.x transmitter module unless, you change the transmitter module's hopping mode to be 1 (predictive). If the transmitter module's hopping mode is set to any other mode other than 1 then the receiver will not connect.
You can just do a RESET of the receiver to reset the channel mapping so all channels are mapped 1:1 to the output ports.
You can just do a RESET of the receiver to reset the channel mapping so all channels are mapped 1:1 to the output ports.