11-30-2021, 07:17 AM
Jim, I have 2 nano's that are acting weird. One is used, the other looked to be new.
I bound them following the procedure power on the nano, bind plug on then removed, power on TX holding the PROG button, release the button and they bind. Power off both, then restart. The TX rapid flashes green, the RX is steady red.
None of the controls work, regardless of which port I plug a servo in. True for both RX.
Same TX on a previously bound model and it works fine
I followed the same procedure with another TX with the same results.
I don't want to return the RX because as I understand it you replace them without trying to fix them and you are out of them at present.
Advice. suggestions?
Thanks
Jeff
I bound them following the procedure power on the nano, bind plug on then removed, power on TX holding the PROG button, release the button and they bind. Power off both, then restart. The TX rapid flashes green, the RX is steady red.
None of the controls work, regardless of which port I plug a servo in. True for both RX.
Same TX on a previously bound model and it works fine
I followed the same procedure with another TX with the same results.
I don't want to return the RX because as I understand it you replace them without trying to fix them and you are out of them at present.
Advice. suggestions?
Thanks
Jeff