10-16-2022, 10:20 PM
You need to program the J1 module's input mode. You have two choices, PPM or XJT-D16. The input mode can be programmed using the push button programming and LED.
Put the module into push button programming mode (like for setting the power, hopping, and input mode). Red=power, green=hopping mode, orange = input mode. The default input mode is 1 flash (PPM). Set it to 2 flashes (XJT).
Once you do this, you MUST rebind any receiver you intend to use in XJT-D16 mode.
Put the module into push button programming mode (like for setting the power, hopping, and input mode). Red=power, green=hopping mode, orange = input mode. The default input mode is 1 flash (PPM). Set it to 2 flashes (XJT).
Once you do this, you MUST rebind any receiver you intend to use in XJT-D16 mode.