Question about Xtreme Protocol

[flyingw]

Recently I asked many question about SBUS, XJT-D16 and PPM with regards to use with the X10+.  This time my question is about Xtreme protocol.

I configure my Futaba 9C transmitter to communicate with an XPS-F1 transmitter module using PPM.  I configure my Taranis to communicate with an XPS-J1 transmitter module using XJT-D16.  In both cases the receivers communicate with their respective X10+s using Xtreme protocol.

Since both arrangements work perfectly, then I reckon that the Xtreme protocol can adapt to the frame rates and data content of either XJT-D16 or PPM.  And, the X10+ PWM output to the servos comes at the same frame rate that the transmitter sends frames to the XPS transmitter module (either XJT-D16 at 18ms or PPM at 22.5ms).

Is this correct?  Thanks,

Paul

[XPS]

Yes, the Xtreme protocol is designed so that any frame rate from from 3ms to 100ms will work correctly. The protocol also works with any number of channels from 1 to 32.

[flyingw]

Yes, the Xtreme protocol is designed so that any frame rate from from 3ms to 100ms will work correctly.  The protocol also works with any number of channels from 1 to 32.

Interesting, thank you Jim.  Paul