XPS Technical Support Forum › XPS Products › X24 › Setup and usage
Basic Installation

Threaded Mode
Basic Installation
XPS Offline
Administrator
*******
Posts: 154
Threads: 17
Joined: Jun 2018
#1
11-12-2019, 01:20 PM
This thread is for discussing the basic setup and use of the X24.
Find
Reply
froilan Offline
Junior Member
**
Posts: 1
Threads: 0
Joined: Jul 2023
#2
07-18-2023, 09:05 AM
I recently purchased a 40% airplane that came with the X24. Original setup had a Jeti receiver. I am converting to spectrum. Is it possible to keep the pre programmed servo matching or do i have to start over? What is the best way to transition to spectrum? Plane has 3 servos on each wing. Two on each elevator half and 2 on the rudder.

Thanks,
Froilan
Find
Reply
XPS Offline
Administrator
*******
Posts: 154
Threads: 17
Joined: Jun 2018
#3
07-24-2023, 11:45 AM
You should be able to just keep the servo matching. The servo centering of the MASTER servo for each surface might need to be adjusted, but that is it. Use the same channels that the JETI was using for the master channels.
Find
Reply




Users browsing this thread: 1 Guest(s)