2 nanos

[rlocke]

i want to place 2 nanos in a glider. it is a tight fit. the question is do i need to keep the master and slave rx apart? i thought of using a thin piece of foam or card board. they would be stacked. maybe they could be end to end. what say you?
thanks, ron

[flyingw]

Ron,

If you must locate them close together, then servo pin end to servo pin end would be better than stacked. If stacked, then the antennas would be too close to each other. The XPS recommendation was to locate the antenna at least two inches away from other electronics or wiring (same rule applies to any RC receiver setup).

Paul

[XPS]

Paul is correct!