So re-did the automatch and it completed it no problem. I then tried the aileron and sure enough it started drawing lots of current when I went to right aileron. Left was ok. So as you suggested I disconnected one servo at a time and moved the active one through full aileron movement no problem. Did the same thing with the other one. No binding.
I did notice one thing when moving just the slave servo in the direction it was binding when they were both connected: as I got to the last 1/5th of my right aileron stick, the servo stopped moving for the amount of stick movement remaining. As if it reached it's endpoint. When doing the automatch, this did not happen at all. My transmitter end points are set to +/- 110 from the beginning and I have not changed them. Nor did I touch any other settings at all. I followed the instructions on page 36. I then un-plugged D1 and E1 and plugged them into two separate channels on the receiver (after disconnecting the sbus feed from the receiver to the X24) I then did a manual old school match with the servos on two separate channels using the same parameters for 45 degree through, just as I did with the X24, and it worked. I did that just to see if I was missing something in the process.
So why won't the slave servo move the same as it did when it went through the automatch? This is very disconcerting.
I did notice one thing when moving just the slave servo in the direction it was binding when they were both connected: as I got to the last 1/5th of my right aileron stick, the servo stopped moving for the amount of stick movement remaining. As if it reached it's endpoint. When doing the automatch, this did not happen at all. My transmitter end points are set to +/- 110 from the beginning and I have not changed them. Nor did I touch any other settings at all. I followed the instructions on page 36. I then un-plugged D1 and E1 and plugged them into two separate channels on the receiver (after disconnecting the sbus feed from the receiver to the X24) I then did a manual old school match with the servos on two separate channels using the same parameters for 45 degree through, just as I did with the X24, and it worked. I did that just to see if I was missing something in the process.
So why won't the slave servo move the same as it did when it went through the automatch? This is very disconcerting.