04-28-2021, 06:03 PM
(04-28-2021, 05:43 PM)XPS Wrote: 1) You can NEVER increase the throw (increase the end point) after doing an AutoMatch. You can decrease it, but not increase it. If you do, you have to re-do the AutoMatch. You always want the absolute maximum throws possible (without mechanical binding), and then set the end points where you want them permanently. Also, never change the end points in the transmitter (at all), or you have to re-do the AutoMatch. You always want to use the X24 for everything though because it uses a 65536 step resolution, compared maximum of a 4096 step resolution for high-end radio systems.
2) Centering/sub-trim is not an issue. The issue only pertains to end points.
Ok. Your answer to #1 is absolutely critical and tells me exactly what I need to do in order to be able to adjust the ailerons (reduce throw only) to get them the same. So I will set mine up for +/- 50 degrees then adjust them down to +/- 45 degrees.
So, I can adjust the aileron surface centering on my transmitter?
What does the fact that group #5 worked mean with respect to my X24?