06-12-2022, 07:01 AM
(06-10-2022, 08:18 AM)XPS Wrote: You have to put the XtremeLink module into "XJT-D16 mode". After that you would set the XJT-D16 protocol in the radio. Once you have done that you can bind just like normal.
You are WAY better off (from a latency standpoint) to use the XJT-D16 mode.
Even with the Nano\X10 combo I'm using 10 channels or less and have been OK with the radio in PPM mode. Curious about the XJT mode. I'm having trouble finding the instructions on how the put the JR module in XJT-D16 mode. Could you point me to the correct manual. If I put the module in this mode will I have to rebind all my Nanos?
I was unable to find the instruction on putting the module in XJT mode in the documents listed below. Perhaps I'm looking in the wrong place or just missing something
xtremelink-1.9.pdf
jr11x.pdf
Thanks for you assistance.