06-12-2022, 10:53 AM
It is not a documented feature in any of our manuals.
Here are the instructions for setting our JR module (the only one that is compatible with OpenTx transmitters) to use XJT-D16 mode:
To use our JR module with an OpenTx based transmitter you need to change the module's input mode to 2. To do that, put the module into push button programming mode (like for setting the power, hopping, and input mode). Red=power, green=hopping mode, orange = input mode. The default input mode is 1 flash (PPM). Set it to 2 flashes (XJT).
To use our JR module with OpenTx you must set the OpenTx based transmitter with these settings:
Set the Internal RF to OFF
Set the External RF to XJT D16
Set the failsafe to RECEIVER
You MUST re-bind any receiver when switching input modes!
Here are the instructions for setting our JR module (the only one that is compatible with OpenTx transmitters) to use XJT-D16 mode:
To use our JR module with an OpenTx based transmitter you need to change the module's input mode to 2. To do that, put the module into push button programming mode (like for setting the power, hopping, and input mode). Red=power, green=hopping mode, orange = input mode. The default input mode is 1 flash (PPM). Set it to 2 flashes (XJT).
To use our JR module with OpenTx you must set the OpenTx based transmitter with these settings:
Set the Internal RF to OFF
Set the External RF to XJT D16
Set the failsafe to RECEIVER
You MUST re-bind any receiver when switching input modes!