X10+
#1
Hello Jim. I wanted to know if you think using the X10+ is ok for use in a 120cc 3D aerobatic plane. I have two of them and before I buy another X24, I was hoping I could use the X10+ instead.

Thank you in advance.

Regards,

Robert
Reply
#2
We can't recommend using them for anything more than 30cc size aircraft. They were actually designed for small foamie jets, where you need a lot of outputs.
Reply
#3
Thanks for your response. What is the criteria that makes it suitable for up to 30cc planes? I ask because the servo bus has been tested up to 80Amps which would make it sufficient even for 40% airplanes. I must be missing something. If you could let me know it would be greatly appreciated.

Thank you in advance.

Regards,

Robert
Reply
#4
Single battery input for one. You would never use a single battery input with anything larger than 30cc size, which is big enough to carry dual batteries.

80A is *barely* sufficient for a 40% size aircraft. Our 33% with 7 JR8611 servos pulls over 60A during a snap to snap maneuver. Larger servos, especially HV types can pull 100A during a high deflection maneuver.
Reply




Users browsing this thread: 1 Guest(s)