06-01-2021, 07:16 PM
Thanks,
Apart from turning ports off in output port menu, I had it right.
( I thought that this was overidden by default)
We just loop through the sequencers.
Sequencers off, A2 and B2 assigned to Ch5 in output menu.
Both servos move.
I have to use a 3 pos switch for retracts in this Tx.
Turn Ch5 A2 and B2 off in output menu.
Turn A2 and B2 for Ch5 on in sequencer menu.
No delays, both set to required levels for trigger, Doors down, oleo down, oleo up, doors up.
Everything's fine apart from sequencing.
Apart from turning ports off in output port menu, I had it right.
( I thought that this was overidden by default)
We just loop through the sequencers.
Sequencers off, A2 and B2 assigned to Ch5 in output menu.
Both servos move.
I have to use a 3 pos switch for retracts in this Tx.
Turn Ch5 A2 and B2 off in output menu.
Turn A2 and B2 for Ch5 on in sequencer menu.
No delays, both set to required levels for trigger, Doors down, oleo down, oleo up, doors up.
Everything's fine apart from sequencing.