06-02-2021, 04:13 PM
(06-02-2021, 02:31 AM)XPS Wrote: It doesn't matter if you use a 2, 3, or more position switch. You just need to make sure that you have the trigger point set correctly. Why do you need a 3 position switch? You really only need a two position switch - either gear is up or gear is down. The sequencer can handle anything that you need to occur for each position.
Can you give us the exact sequence of events that you need to occur? Do you have split gear doors or single? How many gear?
This should be very simple to setup.
I agree, simple, works with a 3rd party sequencer driven off Ch5.
A 3 pos Sw is used because the TX16S only has a single 2 pos Sw available, used elsewhere.
Single doors on Seq#1
Gear on Seq#2
Doors down
Pause
Gear down
Gear up
Pause
Doors up
With a new unit sometimes we can't see the wood for the trees.
When I receive your set up I can verify whether I am suffering Alzheimers or there is something amiss with the unit.
