Posts: 16
Threads: 5
Joined: Apr 2021
Is anyone aware of a 3D printed mount for the nano?
What I have been doing is using a bit of velcro on the "shrink wrap" on the nano. but it you have to move it more than once or twice the wrap starts to come loose from the board.
Any suggestions?
Posts: 10
Threads: 1
Joined: Apr 2021
08-18-2021, 12:40 PM
(This post was last modified: 08-18-2021, 12:43 PM by tande.)
(08-18-2021, 07:36 AM)j_whitney Wrote: Is anyone aware of a 3D printed mount for the nano?
What I have been doing is using a bit of velcro on the "shrink wrap" on the nano. but it you have to move it more than once or twice the wrap starts to come loose from the board.
Any suggestions?
FWIW......I first wrap the Nano 360* with "Scotch" cellophane tape & then attach the "Velcro"......again FWIW
Posts: 16
Threads: 5
Joined: Apr 2021
Posts: 21
Threads: 5
Joined: Apr 2021
(08-20-2021, 05:56 AM)j_whitney Wrote: that's a possibility
If you get some clear shrinkwrap and cut to suit, it gets over the problem.
Been using it for years with velcro segments without any gotcha's.
Posts: 2
Threads: 1
Joined: Sep 2021
(08-18-2021, 07:36 AM)j_whitney Wrote: Is anyone aware of a 3D printed mount for the nano?
What I have been doing is using a bit of velcro on the "shrink wrap" on the nano. but it you have to move it more than once or twice the wrap starts to come loose from the board.
Any suggestions?
Top of the Morning Sir. I do have a 3D printed nano mount. It is 2 pieces and works well. i am using it in several airplanes. I am also going to do one for the X-10 (V1 and V2). I can print and mail or send you the stl file.
Tony Megowan