X10 SBUS input gives steady flickering
#5
That's interesting. 

I tried this with two different RFU's, purchased brand new from XPS, with two different transmitters, at two different locations, and got the same results.

JR 11X with XPS internal 11X module.  RFU set to SBUS and X10 set to SBus.  I did it on both the V1 and V2 X10s.
JR 9303 with XPS-J1 module.  RFU set to SBUS and X10 set to SBus.  I did it on both the V1 and V2 X10s.
All of these tests flickered with this setup.

Same TX's, RFU's, and X10. V1 and V2 set to Extreme mode at same two locations.  None of these tests flickered at all.

I know the preferred method is Extreme Mode with the RFU and X10.  There was a need for them to be both set to SBus but I have gone a different way to make it work.
Reply


Messages In This Thread
RE: X10 SBUS input gives steady flickering - by thebluemax - 01-22-2022, 08:41 AM



Users browsing this thread: 1 Guest(s)