09-10-2022, 05:35 AM
(09-09-2022, 06:51 PM)XPS Wrote: Looking at the source code (because it's been almost 9 years ago that this product was created), it seems that the telemetry setting is NOT changed on a reset. The units are shipped with the telemetry set to 3 (off). Having telemetry enabled might have helped if you had a laptop recording the data, but it would not have changed anything otherwise.
Ok, makes sense. I did use the telemetry almost nine years ago when I was just learning about such things (I pelted you with questions about it). Apparently I never changed it back to off on this RFU, which I am using for good old RC flying.
I have the RFU and X10 installed in a scratch-built Jensen Ugly Stik airplane. The shape of its fuselage and locations of its motor, battery and servos makes it challenging to find a spot for the RFU and its antenna elements that are not behind the plane's equipment at some orientation.
Then I remembered that the X10 supports a second receiver. Can I use a Nano for the second receiver? Would the RFU and Nano act to give diversity, that is, if one receiver can't see the transmitter's signal and the other can, the X10 would take the good signal and a lockout could be prevented?