10-10-2022, 10:41 PM
(10-03-2022, 12:37 PM)XPS Wrote: Solid orange on the Tx module means no signal. Did you program the J1 transmitter module for XJT-D16 protocol?
Tx was put in XJT D16 protocol. Internal module OFF, External module ON
Nano in binding mode (rapid flashing red), power on Tx holding prog button in - when Tx is fully powered on the Tx LED is solid green, as soon as the prog button is released it goes solid orange.
Should I change back to PPM?
(BTW - even though I am subscribed to this thread with notification, I don't get notifications)