X16 Jitters
#1
I just installed a new X16 in a 120" Turbomaster. All channels have a distinct jitter sitting at neutral. I've swapped out servos, Futaba HPS-702 and Savox SV1270TGP. Used three different receivers, even turned off the light above the table. Used 3 different 2S 3800ma LiPo battery packs. Disconnected all servos and extensions one at a time, and had just one servo connected, The jitter remains.
Reply
#2
Were you able to resolve this through our tech support? What receiver? What transmitter?
Reply




Users browsing this thread: 1 Guest(s)