2 nanos
#1
i tried to get 2 nanos to bind as master and slave to no avail. i tried multiple times. each of the nanos worked on channel 1 only.
i gave up and tried to bind both as single use RXs but they only worked on ch 1.
what am i to do?
ron
Reply
#2
Do a RESET of the Nanos. That will reset the channel mapping and enable all of the outputs. Are you preforming the master/slave binding correctly? Most people don't realize that BOTH receivers are bound together at the exact same time.

See here:

https://www.xtremepowersystems.net/forum....php?tid=2
Reply




Users browsing this thread: 1 Guest(s)