08-26-2025, 05:19 PM
(This post was last modified: 09-05-2025, 02:25 PM by Fanglacolla.)
I have been using a slide switch and when powering on and off the X16, the green status light goes out when powering off, seems normal.
When I changed to pin and flag and programed it in the X16, it powers off when the pin is installed but the Green Status light Stays ON.
Would that be normal for using Pin and Flag switching?
Thank You,
When I changed to pin and flag and programed it in the X16, it powers off when the pin is installed but the Green Status light Stays ON.
Would that be normal for using Pin and Flag switching?
Thank You,