Using two RFUs for redundancy

[flyingw]

Jim,

I want to set up a system using an X10+v2 and two RFUs.  I understand that first I must configure the X10+v2 AUX port as a redundant receiver port.

How to I bind both RFUs to work together with the X10?  There is no mention of that configuration in the RFU manual.  The Nano Rx has instructions for setting up a "master/slave" (you may want to update that language) arrangement - would that procedure be the same for RFUs?

Thanks,

Paul

[XPS]

All receivers can be setup as master and slave the same way.

[flyingw]

Ok thanks Jim, Paul